GS 715W Bifacial Solar Panel Double Glass – Javed Lucky Solar
The GS 715W module is built using format 210mm monocrystalline half-cut cells. It uses N-Type TOPCon technology, which helps power degradation and performs better in low-light situations. The module has a dual-glass structure. Both the front and rear are made of 2.0 mm heat-strengthened glass. This design gives it resistance to tough conditions like strong wind, heavy snow, dust and moisture that can cause corrosion.
Unlike solar panels that only collect light from the front this panel is bifacial. That means the back side can also capture light reflected from the ground. This reflected light, known as albedo turns into energy. The amount of power depends on the surface below. For example gravel, concrete or white roof membranes can boost energy output by 10% to 30%.
The panel comes with an IP68-rated junction box. This means it’s protected against dust and water when submerged. It also has MC4- connectors. These features make sure the panel works safely in all types of weather from heat, to freezing cold.
| Technical Parameter | Specification / Rating |
| Rated Maximum Power | 715 W |
| Cell Type | Monocrystalline N-Type TOPCon |
| Module Efficiency | ~23.0% |
| Open Circuit Voltage | ~48.5 V – 48.8 V |
| Maximum Power Voltage | ~40.6 V – 41.0 V |
| Short Circuit Current | ~18.55 A – 18.64 A |
| Maximum Power Current | ~17.44 A – 17.63 A |
| Power Bifaciality Rate | 80% |
| Dimensions | $2384mm |
| Weight | ~37.8 kg – 38.2 kg |
| Front / Rear Glass | Dual 2.0 mm Heat-Strengthened Glass |
| Frame Material | Anodized Aluminum Alloy |
| Junction Box | IP68 Rated (3 Bypass Diodes) |
| Maximum System Voltage | 1500 V DC |
| Operating Temperature | -40°C to +85°C |
| Mechanical Load | Front: 5400 Pa / Rear: 2400 Pa |
Key Features
Ultra-High Energy Output: Provides 715W peak power with a good module efficiency of up to 23.0% which reduces the space needed for installation and the amount of mounting hardware required.
Double-Sided Generation (Bifacial Gain): Has an 80% bifaciality rate that adds between 10% to 30% power generation from the back side.
Superior Temperature Coefficient: Works in hot areas with a low temperature coefficient of -0.29°C, which helps reduce power loss when temperatures are high.
Enhanced Letid Resistance: Uses advanced TOPCon cell technology to protect against Potential-Induced Degradation and Light-Induced Degradation to ensure power stays consistent over time.
Robust Weather Durability: Covered in heat-strengthened glass and an anodized frame it is built to handle 5400 Pa snow loads and 2400 Pa wind forces.
Optimized System Economics: Helps reduce the Levelized Cost of Electricity and the Balance of System costs by providing power, per string.






Reviews
There are no reviews yet.